Sentence examples for molar calculated from inspiring English sources

The chin point was found to move forward 4.8 mm for 5.4 mm superior positioning measured at the occlusal point of the maxillary first molar (calculated ratio = 1 0.88; r = 0.789) [15].

Ratios are molar, calculated as described in Table 1.

To perform the chelator ligation, 100 μL antibody solution (75 150 μM, PBS pH 7.4) was combined with 200 μL buffer (PBS pH 7.4) and a 10-fold molar excess of either Tz-DOTA or Tz-DFO in 10 μL DMSO (molar excess calculated based on initial norbornene reaction stoichiometry).

The mean ± SD rate of bone resorption between the first and second measurements in the canine and first molar was calculated, with the mean ± SD in those teeth in relation to the ipsilateral third molar, and grouped into categories with or without the lamina dura and the radiolucency below the crown of the third molar.

The mean ± SD rate of bone resorption between the first and second measurements in the canine and first molar was calculated, and the mean ± SD in those teeth in relation to the ipsilateral third molar, and was grouped into two categories with or without the lamina dura below the crown of the third molar.

where d A and d A * are the molar flows (calculated and desired) of the A (light) component in the distillation; s B and s B * are the molar flows (calculated and desired) of the B (intermediate) component in the lateral stream; b c and b C * are the molar flows (calculated and desired) of the C (heavy) component in the bottom stream.

C/O molar ratios calculated according to the XPS analyses are 2.3 and 6.1 for GO and RGOA, respectively.

The correct composition of a specific inclusion corresponded to that for which the molar volumes calculated using the two programs corresponded.

The PY molar content calculated based on the 1H NMR spectra is slightly lower than feed PY content when feed PY content is lower than 30moll%.

The actual MPD/EOA molar ratio calculated based on 1H NMR spectra of the polymers is different from element analysis results.

Molar masses calculated from a universal calibration curve and the viscometry detector are shown to be erroneous for the freely draining PHIC and should not be used for persistence length determination.