Sentence examples for mol at a from inspiring English sources

Li-insertion properties were evaluated as anodes in the half-cell configuration (Li/Bio-TiO2) and it is found to demonstrate reversible insertion of 0.61 mol at a current density of 33mAA g−1.

To examine the effect of etching time on the geometry of the etched GaAs structure, chemical etching was prolonged in 20 mol dm−3 HF and 0.01 mol dm−3 KMnO4 at a relatively low temperature of 20 °C.

Differential pulse voltammetry (DPV) measurement at β-CDP/rGO/GCE modified electrode revealed that the reduction peak current increased linearly with the concentration of IDP in linear range of 5 × 10−8 to 1.5 × 10−5 mol L−1 and 2 × 10−5 to 1.5 × 10−4 mol L−1 with detection limit of 2 × 10−8 mol L−1 at a signal-to-noise ratio of 3.

Reliability and efficiency of diaphragm-free device with dynamic reference electrode was confirmed in the thermal convection corrosion loop operating more than 1200 h with molten 15LiF 58NaF 27BeF2 mixture (mol%) at a maximum temperature of about 700 °C.

At an optimum condition this photoelectrocatalytic method can produce active chlorine at levels compatible to water disinfections processes using a chloride concentration higher than 0.010 mol L−1 at a pH of 4 and a current density of 30 mA cm−2.

The sensor exhibited a linear response to H2PO4− in the concentration range from 1.0 × 10−5 to 1.0 × 10−1 mol L−1 at a pH range from 4.0 to 6.5 with a slope of −39 mV dec−1.

Keeping constant the hydrophobe level (20 mol%) at an alkyl chain length x = 6, increasing NH from 9 to 30 increased the elongation ratio at break from 125 to 250%.

In the pathway of l-glutamic acid (l-Glu) biosynthesis in Corynebacterium glutamicum, 1 mol of l-Glu is synthesized from 1 mol of glucose at a cost of 1 mol of carbon dioxide (CO2), with a maximum theoretical yield of 81.7% by weight.

Chemical etching was conducted in solution containing 0.001 mol dm−3 KMnO4 and 20 mol dm−3 HF at a relatively high temperature of 45 °C.

In this MoMaS benchmark case, our simulation showed that this threshold value was about 1×10−3 mol H 2 per mol of water at a pressure of 1×106 [Pa].

The adsorption of 35S labeled HSO4 and SO2−4 ions was studied in acid (0.1 mol dm−3 HClO4) and neutral (0.05 mol dm−3 KClO4) media at a smooth copper electrode.