Sentence examples for moisture content control from inspiring English sources
Here, we first validated P moisture content control by comparison with bed temperature control.
Furthermore, we observed that when the target temperature was higher than the measured value of inlet air temperature the P moisture content control response was accelerated.
In summary, P moisture content control has good scalability and can be introduced without changing granulation conditions in the development of orally administered pharmaceutical products.
We then confirmed that P moisture content control is effective in maintaining the moisture content, and in minimizing the variance of the particle size of granules following granulation.
The objective of this study was to investigate a novel light backscatter sensor, with a large field of view relative to curd size, for continuous on-line monitoring of coagulation and syneresis to improve curd moisture content control.
For process control of fluidized bed granulation process, we investigated proportional (P) moisture content control via adjustment of inlet air temperature in proportion to the difference between measured and target moisture content of granules.
Figure 1b shows the significant reduction in moisture content in control and all zeolite treatments during the process (F = 92.8, p < 0.05).
The evolution of moisture content was controlled, and both methods were compared by means of a statistical analysis of the thickness, quality, porosity coefficient, color and compressive properties of the cork.
In this study, rhizosphere soil moisture content increase than control, probably due to the increase of soil organic matter and soil water holding capacity.
This level, however, did not show significant (P < 0.05) difference with the BSFM25 and ACM25 diets that were produced at 20% feed moisture content, or the control diet that had 30% feed moisture content.
Moisture mass balance during granulation and drying stages can be mathematically predicted using moisture balance of inlet and outlet air humidity and desired granule moisture content can be controlled through process parameter adjustments primarily via spray and air flow rates.
