Sentence examples for modulus would be from inspiring English sources

This model predicts a critical strain above which platelet buckling, and hence a reduction in the compressive modulus relative to the tensile modulus, would be expected to occur.

It was also observed that increases in tensile strength and modulus would be attained for nanocomposite samples with 10%, 5% and 4% (by weight) of water, PVOH and clay loading, respectively.

According to composite theory, there is no requirement that the fibrils should extend from one end of the tissue to the other; indeed, an interfibrillar matrix with a low elastic modulus would be sufficient to guarantee the mechanical properties of the tendon.

For conical indentation into tilted samples, of materials exhibiting either sink-in or pile-up, it is found that the projected contact area would be underestimated by the Oliver and Pharr (O&P) method; consequently, the hardness and elastic modulus would be overestimated.

Only a load in the center was used for the example, but the main result (decrease in stress with a decrease in concrete modulus) would be obtained for other load locations (corner or edge).

Using parametric computational analysis of high-resolution micro-CT-based finite-element models of cores of elderly human vertebral trabecular bone, a specimen-specific correction factor for the side-artifact was quantified as the ratio of the side-artifact-free apparent modulus (Etrue) to the apparent modulus that would be measured in a typical experiment (Emeasured).

On the other hand, alloying does not normally affect the elastic modulus of metals significantly, so that automotive door panels or hoods made from aluminum alloys, all of which have approximately one-third the modulus of steel, would be floppy and suffer large deflections when buffeted by the wind, for example.

The larger the shear modulus the smaller would be the change in airway diameter, and since μ is directly proportional to Ptp [29], an increased lung volume would also lessen the airway diameter changes.

Estimation of this modulus would not be possible with a standard AFM alone or a rheometer.

Decreased elastic modulus and yield stress would be beneficial to tissue engineering of elastic tissues including skin.

However, by considering the rod-like conformation adopted by the PAN chains, and comparing it with polymers which adopt a helical form, it was estimated that the maximum tensile modulus of atactic PAN would be about 55 GPa.