Sentence examples for modulus in a from inspiring English sources

An exact analytical solution is presented for the effective dynamic shear modulus in a heterogeneous fluid-filled poroelastic medium containing spherical inclusions.

We find that rubber around the ZnO particles exhibits a higher Young's modulus in a shell with a width up to about 200 nm.

It was used to show that compressive modulus should not be reduced relative to tensile modulus in a typical polypropylene nanocomposite.

It is a tradeoff between getting a high value of the modulus of a complex number, getting a stable value of this modulus in a time as short as possible, and leading to low variations of the temperature of the product passing through the thermal device.

Acoustic measurements and analysis by the Hill approximation revealed that a low Young's modulus in a polycrystalline form is caused by the low shear modulus c′, related to the low β-phase stability, low c44, and relatively low bulk modulus B compared with those of binary Ti-based alloys.

For the arctic conditioned samples, cenospheres/epoxy foams did not present visible signs of degradation prior to testing, but manifested a reduction in compressive modulus in a range of 47 57% and 47 65% for untreated and treated cenospheres/epoxy syntactic foams as compared to their unconditioned counterparts.

Considering that the plastic state can effectively improve the bearing capacity and reduce the engineering cost, to investigate the radial subgrade modulus in an elastic-brittle-plastic rock mass, modified analytical solutions are derived that are compatible with a generalized nonlinear unified strength criterion.

Using numerical ray tracing, the paper studies how the average distance modulus in an inhomogeneous universe differs from its homogeneous counterpart.

Martone et al. [5] investigated the effect of dispersed multi-walled carbon nanotube (MWCNT) on the enhancement of elastic modulus in an epoxy system.

The tests show that the reinforced foams had a higher modulus in all cases.

The two deformation parameters allow the proposed surface to change in aspect ratio as it deforms, and allow a negative hardening modulus in shear without a negative hydrostatic modulus.