Sentence examples for modulus derived from from inspiring English sources

The tensile yield stress, Yt, is shown to correlate with hardness following H∼3Yt while H∼Et/10 (Et is Young's modulus derived from tensile experiments).

Young's modulus derived from the elastic response according to Hertzian contact theory is 76 and 98 GPa for (010) and (111) GPa, respectively.

The correlations equations by which resilient modulus can be obtained from Young's modulus derived from laboratory data are: Open image in new window Fig. 7 Regression of resilient modulus values with Young's modulus values computed from laboratory CBR {M}_R=33.048 Inleft {E}_Rright -62.776 (8) {M}_R=1.065{E}_R+12.69 (9) {M}_R=0.440{E}_R + 43.384 (10).

The stress was calculated as the force applied divided by the cross-sectional area of the helix, while the Young's modulus was derived from the slope of the stress strain diagram after linear regression fitting.

A new concept named Catalyst Modulus was derived from the kinetic equations and then verified with experimental data; the fit of this parameter was very high, thus, pointing out the validity of the model.

Finally, the experimentally measured hardness and Young's modulus, as derived from the load displacement data, are as high as 31.7 and 314 GPa, respectively.

The effect of nanoparticles on viscosity or, in the case of elastomers, the effect of nanoparticles on the elastic modulus is derived from hydrodynamic [45 47] or elastic equations [48].

The values for the bending modulus were derived from the stress-strain curves obtained from the bending tests, as described previously (Shinzato et al. 2002).

In this QNM mode technique, the elastic modulus is derived from the force indentation curves by using 2 different models: (i) the Hertz Sneddon model (Sneddon, 1965) or (ii) the Derjaguin-Muller-Toporov (DMT) model (Derjaguin et al., 1975).

The majority of studies used densitometric and/or density-modulus relationships derived from different anatomical locations scanned in different scanners with different scanner settings.

The values of Young's modulus and shear modulus can be derived from the above values, all of which are listed in Table 1.