Sentence examples for moduli at the from inspiring English sources

The resultant bulk moduli at the corresponding Q values are plotted in Fig. 3.

So, the "s" and "N" parameters induce the highest range of variation in Young's modulus, while the bulk modulus shows the smallest change among all moduli at the same conditions.

The comparison of the modeling results with the experimentally determined elastic (macroscopic) moduli at the scales of cement paste, mortar, and concrete is satisfactorily good, underlining the predictive capability of the modeling approach.

In addition, we measured tangent shear moduli at the limiting state as well as after strain localization, and evaluated a reduction ratio of shear moduli due to liquefaction, which would be employed in the ALID framework.

Due to the radial gradation, the circumferential moduli at the outer position were 2.3, 1.9, and 2.6 higher than those at the inner location for Moso, Tre Gai, and Guadua, respectively.

The storage moduli at 37 °C of the nanocomposites were higher than those of the microcomposites.

Here we demonstrate that the storage moduli at 37 °C and the glass transition temperatures of quenched poly-l-lactide/α-tricalcium phosphate nanocomposites were lower than those of annealed nanocomposites while the damping factor tanδ values of the quenched nanocomposites were higher than those of the annealed nanocomposites.

Further investigation of the effect of the PLA concentration on the elastic (G′) and the plastic (G″) moduli showed a sudden increase of the elastic moduli (G′) at the critical chain entanglement concentration.

DMA tests suggest the formation of a combined polymer-CNT continuous network evidenced by measurable storage moduli at temperatures above the glass transition temperature (Tg), consistent with a mild reinforcement effect.

The stiffness of the bitumen was enhanced at low temperatures by 100 fold and at high temperatures to an even greater extent by the polymers, the sole exception being blends of an atactic polypropylene, whose moduli at low temperatures were the same as the bitumen.

The theoretical modulus increases with increasing molecular rigidity, while the experimental moduli (at low temperature and corrected for the cross-sectional area of the side chains) do not exhibit a specific dependence on the molecular rigidity, and range between 140 and 180 GPa.