Sentence examples for modified samples in from inspiring English sources

Moreover, the corrosion resistance of bare and modified samples in seawater were investigated by cyclic voltammograms(CV) and electrochemical impedance spectroscopy EIS).

The shear and elongational rheology were found to be dependent on the LCB structure, and the strain hardening behavior of modified samples in transient elongational viscosity confirmed the existence of long branched chain.

No changes in toluene conversion were observed for all parent and modified samples in toluene alkylation confirming diffusion and transport of products as the rate determining step in 10-ring zeolites.

ZSM-5 zeolites modified with Cu+ ions were prepared either by the high-temperature chemical reaction of hydrogen form with CuCl vapour or by the wet ion exchange with subsequent reduction of the modified samples in CO at 873 K.

In this experimental system, the behaviour of the modified samples in relation to the evolution of the content of mmr and rrmr structures rather approximates to that obtained for basic solvents.

The NOESY spectra of unmodified and modified samples in H2O were collected at 5 °C with mixing times of 70 and 250 ms at 600 MHz.

The reflection of modified sample in the visible region (400 to 700 nm) is a little higher than that of the unmodified sample, which may be caused by the colour deviation in the modification process [38].

The increased abundance of monomeric and oligomeric SOD1 in endogenously modified samples and in vitro glutathionylated WT and G37R SOD1, which contain only a single glutathione modification, supports the conclusion that Cys-111 glutathionylation is predominantly responsible for the observed promotion of dimer dissociation and oligomerization.

For modified samples shown in Figures 2, 3, 4, 5, and 6, the shift in the energy gap could be attributed to the formation of polarons in the modified films.

Two series of samples were produced in the presence (modified samples: PTX) and in the absence of Triton X-100 (unmodified samples: PT) at bath temperatures ranging from 25 100 °C.

After both the etching process and the synthesis of diamond like carbon DLC coating, the modified samples were analysed in terms of the changes in surface geometry, its chemical composition, nano-scale mechanical properties, the contact angle and the surface free energy, as well.