Sentence examples for modification of the maximum from inspiring English sources

We demonstrate that states of a hidden Markov model “grown ” using a novel modification of the maximum likelihood successive state splitting algorithm correspond very well with the phones of the language.

To investigate the possibility of smaller clusters, the same analysis was performed with a modification of the maximum spatial cluster size which was defined as ≤ 30% total population.

For each phosphorylated serine, we have reconstructed the evolution of this site in the corresponding taxonomical group using a fast modification of the maximum likelihood algorithm (A. Goland, in preparation).

At each bending radii, the complete GMR curve is measured providing access to the modification of the maximum achievable GMR ratio and the corresponding sensor sensitivity upon bending at a field parallel to sensors plane.

This results in m values for σ ^ l 2 and those are used to define the shrinkage factor for ridge regression as λ l = σ ^ e 2 / σ ^ l 2. We abbreviate this procedure RMLV (i.e., modification of the restricted maximum likelihood procedure that yields heteroscedastic variances).

The first approach is a modification of the Genetic Algorithm –maximum likelihood discriminant analysis (GA-MLHD) method originally developed by Ooi and Tan [54].

For each of the peak lists two searches were performed: 1) tryptic search and 2) a semi-tryptic search with methionine oxidation set as a variable modification and carboxymethylation of cysteins as fixed modification and the maximum mass error tolerance for precursor and products ions at respectively 1.2 and 0.8 Da.

During the modification process, the maximum temperature reached 1500 °C in the mid-bottom part of CFu.

We propose a minor modification of their maximum entropy method that significantly improves the quality of the estimate.

Results show that under the same load, parabolic modification can reduce the maximum value of contact force and tooth root stress of beveloid pinion.

Measurement conditions were set according to the values recommended by the manufacturer with some modification; the maximum number of peaks for MS/MS acquisition per spot, the S/N filter, and spot-to-spot tolerance were set at 10,100 or 150, and 200 ppm, respectively.