Sentence examples for modes with sufficient from inspiring English sources

Compared with the 1D equivalent circuits, the 2D equivalent circuit gives a more comprehensive predicts of the thickness and radial modes with sufficient accuracy when the ring or disk is thin.

Relatively small values of ( rho_{pfb}^{U} /rho_{pfb}^{B} ) imply that a beam prestressed with unbonded tendons would fail in a compression-controlled mode with sufficient margin of safety if prestressed with ( rho_{pf}^{U} ge rho_{pfb}^{B} ).

A relatively small value of ( rho_{pfb}^{U} /rho_{pfb}^{B} ) suggests that a beam prestressed with an unbonded tendon and its reinforcement ratio greater than the balanced ratio (( rho_{pf}^{U} ge rho_{pfb}^{B} )) would fail in a more desirable compression-controlled mode with sufficient safety.

Until now however, in most cases a Q-TOF (or ion-trap time-of-flight) mass spectrometer has been the ion-trap time-of-flightablion-trap time-of-flightent sension-trap time-of-flight and mass 2 with spectrometerensitivity and resolution and thaspossibeentheof analyte fragmentatinstrument

Then, Section 4 presents the numerical results to demonstrate the advantage of using the band-AMC mode with the sufficient number of CQI reports for the selection bands.

Distributed reactions can also be achieved in premixed mode of operation with sufficient entrainment of burned gases and faster turbulent mixing between the reactants.

Extracting displacement ratios and geometric spreading for individual modes of propagation succeed with high accuracy in regions with sufficient mode separation.

Two numerical examples show that a small number of measured modes can produce PFMs with sufficient accuracy to correctly locate the damages by the DLV method from output-only data.

Since the approximations present in the theoretical method do not allow the estimation of these frequencies with sufficient accuracy, low-frequency modes were omitted in the calculation of ADPs.

"At this time, 10 kilowatts is the highest single-mode power available in a commercial laser with sufficient beam quality for this application".

The test results reveal that a joint consisting of parallel perfobond ribs and a joint consisting of studs with sufficient reinforcement show the similar beam strength and failure modes resulting from the failure of the PSC components.