Sentence examples for modes with decreasing from inspiring English sources

The films grown on c-plane sapphire show stiffening of A1g and E12g phonon modes with decreasing number of layers for both MoS2 and WS2.

This mode can be considered as a transition zone, where the stabilized propagation mode transits to the non-stabilized propagation mode with decreasing initial pressure.

The evolution of the dynamic response of the resonance mode with decreasing aerodynamic damping is discussed by means of both perturbation and numerical methods.

The peak of the longitudinal optical mode decreases while the transverse optical mode increases, with decreasing residence time and NC size.

Features oriented perpendicular to the debond propagation direction (lines and pads) exhibited a significant increase in toughness (from 3 to 30 J m−2 under mode I) with decreasing feature size (from 250 to 25 μm) for both mode I and mixed-mode loading, while no size-dependence was observed for debond propagation in the direction parallel to the bonded lines.

Moreover, we should bear in mind that the whistler-mode wavelength increases with decreasing plasma density.

The swelling factor of the O-mode waves also decreases with decreasing latitude, and the O-mode wave swelling factor in Haikou is only 4.5.

Figure 7c shows that the integrated intensity increases in the single phonon LO mode with decreasing T A, in comparison with that in two-phonon 2LO mode.

The increasing contribution of the TM mode with decreasing wavelengths can be attributed to another cause of low LEE in AlGaN deep UV LEDs.

The resonance wavelength of the FP cavity mode has a redshift with decreasing P. In the shorter wavelength range of λ < 350 nm, there is no significant enhancement of the absorption over the planar reference as the absorption is inherently strong for the a-Si material.

Further, the distance between the X- and O-mode wave reflection points decreases with decreasing latitude.