Sentence examples for modes were simulated from inspiring English sources

Multiple deformation modes were simulated, including strip biaxial, planar biaxial with two attachment methods, and membrane inflation.

Three commonly-used operation modes were simulated: continuous, non-continuous intermittent and dynamic, and each mode was applied at four different pressure levels.

Different operating modes are simulated.

The confinement factors and near field profiles for various optical modes are simulated.

Then the flow field distributions of these flow modes are simulated by using the computational fluid dynamics software.

In this study, two electrolyte flow modes, i.e. the flow-by and flow-through modes, are simulated by using a three-dimensional H2/Br2 RFB model.

The design and the control scheme performances in all modes are simulated in MATLAB and validated through real time hardware in loop (HIL) system.

The variations of the total specific energy consumption and the discharge brine concentration for various hybrid modes are simulated to verify the conceptual designs.

Although the quadratic combination rule is used in defining the load pattern, the effects of reversal signs in the higher modes are simulated in the load pattern.

Finite Element contact models of reconstructed hips, subjected to physiologically-based boundary constraints and peak loads of walking mode, were simulated using a coefficient of friction of 0.4 and an interference-fit of 50 μm.

First, following [1, 3] the degradation in the spatial resolution due to the fractional aperture synthesis mode were simulated via blurring the original image with the range AF along the y axis and with the azimuth AF along the x axis, respectively.