Sentence examples for modes the slope from inspiring English sources

An important finding was that for a wide range of knit architectures, which had similar failure modes, the slope of the regression line for normalised CAI strength was constant, consequently, the slope of the regression line for actual CAI strength varied linearly with undamaged strength.

For both the tensile and bending test modes, the regression slope and the intercepts of the ultimate strain and postyield work versus the carbonate substitution ratio and collagen cross-link ratio are not significantly different for the two donors, indicating that the same regression model is appropriate.

The results show that failure mode of the slope under seismic load is consistent with the actual situation when the lowest material parameters are used.

The major failure mode of the slope is sliding along the fault F5, and local collapse of the hanging body at the top of the slope under dynamic or rainfall load.

A sliding mass resting on an inclined plane and composed of two blocks separated by a vertical tension crack is considered, and a disjoint cut-set system formulation is proposed, with each cut-set corresponding to a different failure mode of the slope.

From the examples the authors analyze in their paper, it becomes evident that for polymers for which sub-Rouse mode appears, the slope of the low-frequency side is around 0.4, as in our case.

Thus working under this mode of performance the slope of the curves of CO2 concentration, for instance, drastically diminishes.

As the wave number increases, other high modes appear; one of the modes seems to be associated with quick change in the slope of the mode.

Under probit analysis, the median lethal concentration expresses the mean (mode), and the inverse of the slope of the regression line expresses the standard deviation of the normal distribution of tolerance thresholds.

The results showed that changes in the slope across task modes were partially replaced by those in the asymptote level.

If a support is positioned within a finite element then the shape functions are used to calculate the contribution of the support to the system stiffness and also the slope of the mode at the support.