Sentence examples for modes the calculated from inspiring English sources

The results of the discrepancy caused by the F3 illustrate that for each of the aforementioned three failure modes, the calculated original SMR index is smaller than, or equal to, the real value, and the designed slope might be conservative and not economical.

The results of the discrepancy analysis from F1 illustrate that, with respect to each of the aforementioned three failure modes the calculated original SMR index is larger than, or equal to, the real value, and the designed slope is possibly in danger.

At each tuning range (mode), the calculated phase noise of the proposed ring oscillator at each tuning range (mode) was −87, −85, −81, and −79 dBc/Hz at a 1 MHz offset from the center frequency.

On the maximum efficiency mode, the calculated conversion efficiency is 27% for the AMTEC system and 19% for the overall receiver system with the output power is 10.3 kWe at 1000 K.

According to the results presented in Fig. 7, for majority of the capacitive mode the calculated impedance does not fall into the proper protection Zones.

This, added to the great similarities between the calculated modes and the experimentally measured ones, is a strong proof of the band inversion that happens between the p and the d bands in any metamaterial composed of resonant scatterers and for which near field inductive or capacitive couplings can be safely neglected.

b The calculated mode loss spectrum based on transfer matrix simulation with different AR coatings.

In order to investigate the confined SPP modes, we calculated the cavity modes for the cavities with L values of 40 and 120 nm, respectively.

The insets depict the electric field profiles (|E x)|) of the involved modes as calculated at the bottom and top end of the pump sweeps shown in a,b.

To demonstrate the interference of the dipole mode and the quadrupole mode, we calculated the electrical field distribution at the interface of the metamaterial light absorber and the metal substrate.

The resonance and antiresonance frequencies and the vibrating modes are calculated for the various resonance modes and boundary conditions, and the results are compared with those by the three-dimensional finite element methods.