Sentence examples for modes showing that from inspiring English sources
The optimal engine transients and their duration are seen to be dictated by the stationary efficiency of the different drivetrain modes, showing that the ratio between the efficiencies of the electric and mechanical path dominates the dynamics and have a greater effect than the engine and turbocharger dynamics.
(B ) Scatter plot of membrane potential of cells in tonic vs bursting modes showing that tonic modes occur at more depolarized potentials than bursting mode (N = 8 cells for tonic mode and 11 cells for bursting mode).
DOI: http://dx.doi.org/10.7554/eLife.10559.017 10.7554/eLife.10559.018 Appendix figure 8. Parameters in the two modes showing that the filter defining 'effective treatment' does not change the relationships between parameters and whether treatment increases or decreases resistance.
The failure modes showed that Angelim compared to Douglas is more plastic, while Douglas is more brittle.
Results using these renormalized modes show that the calcium and magnesium oxide composition in CMAS can be generally quantified.
Comparison between symmetric and asymmetric regarding strength and failure modes shows that structural asymmetry can intensify lateral flexibility.
The good agreement between CCDs obtained by both modes showed that the molecular-weight effect on the CCDs is negligible.
The changes in the perchlorate anion's Raman modes show that in the polymeric matrix most of the lithium and perchlorate ions are separated by the polyacrylamide coils.
Furthermore, the analysis of the relative intensities of the O H stretching modes shows that the number density of tetragonal water structures differs between the hydrogels.
Analysis of nonlinear normal vibration modes shows that a stable localized vibration mode, which provides the vibration regime appropriate for an absorption, exists in a large region of the system parameters.
The contrast analysis on the effective ratio of the transverse bending rigidity values under different load levels with different bolt pre-tightening forces and different assembly modes shows that value of the stagger-jointed segmental ring is obviously lager than that of the straight-jointed segmental ring, and that difference decrease gradually with the load increasing.
