Sentence examples for modes of plastic from inspiring English sources

Twinning and dislocation slip are two major and competing modes of plastic deformation in metals and alloys.

This article provides a review of the multiple damage modes of plastic gears, including both general and plastic gear-exclusive modes.

The Portevin Le Chatelier effect (PLC), discontinuous plastic flow phenomenon (DPF) or Lűders band propagation effect are the most prominent modes of plastic deformations, that are characterized by an oscillatory behavior (plastic instability).

It is thus evidenced that slip is the major mode of plastic deformation in nonpolar m-plane GaN.

Crystallographic slip is the dominant mode of plastic deformation in this material.

In addition, the effect of matrix anisotropy on the mode of plastic flow localization is discussed.

It is revealed that in addition to the film thickness, the mode of plastic deformation depends on the stress state.

Inversion is a mode of plastic deformation which develops when a thin-walled tube is compressed between a flat plate at one end and filleted die at the other (Al-Hassani et al. 1972a; Reddy 1992a).

An attempt has been made to illustrate a new physical mode of plastic deformation in nanocrystalline materials that synergizes two processes, i.e. grain boundary (GB) sliding and stress-driven shear-coupled GB migration.

Stress-driven migration of low-angle grain boundaries (LAGBs) having deformation-distorted structures is theoretically described as a special mode of plastic deformation in nanocrystalline and ultrafine-grained materials.

This study examines three possible failure modes of acetal plastic toilet water supply nuts.