Sentence examples for modes of coatings from inspiring English sources

The failure modes of coatings could be classified into two main categories, i.e., spalling and delamination.

As the abrasive modes of the coatings are not varied after short-time heat treatment, the hardness of the coatings plays a dominant role in the wear resistance of the coatings.

At the same time, the main failure modes of the coatings changed from abrasion and spalling to delamination.

Coating microstructures, their mechanical and elastic properties and residual stresses were taken into consideration when estimating the thermal cycling properties and failure modes of the coatings.

The failure mode of DLC coatings on 316L stainless steel and CoCrMo alloy in the friction test is coating delamination.

The plastic deformation in the substrate is due to the interfacial crack extension, so the interface crack mode of PEO coatings is ductile crack.

According to the obtained results, this mode of application not only produced coatings with a denser and finer columnar structure but also resulted in a substantial reduction in the number of MPs.

The current work provides a detailed analysis of the microstructure, mechanical properties, and out-of-plane compression failure modes of tungsten micro-architectured coatings.

The modes of corrosion protection by coatings are described and how each of these models can be achieved in a coating system.

This then allows the failure modes of particulate filled thermoset coatings and their location to be identified from the acoustic emission detected during the four point bend test.

In this study, particulate filled thermoset polymeric coatings with two different coating thicknesses were subjected to four point bend loading while being monitored by acoustic emission in order to establish the failure modes of the filled polymeric coatings.