Sentence examples for modes by applying from inspiring English sources
The ratio of incident modes of defected systems with respect to clean systems can be calculated from the difference of these individual modes by applying the appropriate photonic Green function.
In the proposed design, a control circuit with the least possible number of transistors is proposed which changes power MOSFETs threshold voltages adaptively depending on their operating modes by applying voltage to the body of the MOSFETs.
Using this property of the structure, coupling of the incident wave to the surface modes of the structure is used to enhance the lateral displacement of the totally reflected wave, known as Goos-Hänchen shift, while it is also shown that this large lateral shift can be controlled through adjusting the dispersion properties of the surface modes by applying an electrical voltage.
The nanoindentation is performed in a displacement-controlled mode by applying a constant velocity of 20 m/s to the probe.
3) Turning the unneeded PMs in the data center to the sleep mode by applying intelligent power management decisions in order to reduce the consumed energy. .
The conductive properties of single Si NWs were investigated by CAFM in contact mode by applying a DC voltage between the tip and the sample with a Pt-Ir-coated Si tip.
The surface potential and topography were determined under a non-contact mode by applying AC voltage with amplitude of 1 V (peak to peak) and frequency of 70 kHz to get clear images and sufficient sensitivity.
For the LDE QD fabrication, the nanoholes were filled with GaAs at a substrate temperature of 600° in a pulsed mode by applying several pulses with 0.5 s growth and 30 s pause, respectively.
The nanoholes were filled with GaAs at a substrate temperature of T = 600°C in a pulsed mode by applying n P pulses with 0.5 s growth and 30 s pause, respectively.
To inspect the equivalent circuit model of the device, we measured the impedance of the device in HRS and LRS in the Z-Z mode by applying 20 mV of AC small signal (40 Hz to 110 MHz) to the device.
The so-called Deflectometric Flatness Reference (DFR) is designed to measure in the direct deflectometric mode by applying an autocollimator and a scanning pentaprism, and in the difference deflectometric mode corresponding to the Extended Shear Angle Difference (ESAD) principle invented by PTB.
