Sentence examples for modes at high from inspiring English sources

In particular, it does not predict the subtleties of the sensitivity of certain modes at high frequencies, nor any sensitivity for the torsional fundamental mode.

Muscle deformations were recorded by two ultrasound imaging modes at high time resolution (m-mode and tissue velocity) in separate sessions and compared to simultaneously recorded intramuscular EMG in three abdominal muscles.

This is usually implemented in the form of low-order compensation and reduced bandwidths to gain-stabilize uncertain modes at high frequency and maintain large reserves of gain and phase margin over a range of crossover frequencies.

Normally, fatigue crack growth occurs along with superimposed environmental effects at low crack-growth rates (or low ΔK values) and/or with monotonic fracture modes at high crack-growth rates (or high ΔK values).

This is owing to the feature of decreasing the cross-correlation of WPFs at high frequencies and the fact that the WPF does weakly couple into the structural modes at high wavenumbers such that 2πf/Uc

The facility can operate in two modes: at high (MHz) repetition rate with flux and brilliance similar to that of a beamline at a large 2nd generation synchrotron, but with short ∼1 ps pulses, or as a 10 Hz high flux-per-pulse single-shot machine.

With this new design, existence of higher order modes, mode instability at high power levels, mode shrinking and gain reduction upon bending has been solved and the bending loss is negligible in the frequently used bending radius of 3 cm to 5 cm.

The influences of the alloying contents on the texture evolution are discussed in terms of the activation of non-basal slip modes at higher temperatures and the mechanisms of dynamic recrystallization.

The main role played by isotropic amorphous regions during the first steps of deformation and the initiation of enthalpic deformation modes at higher strain levels were observed either by WAXD or μ-Raman spectroscopy.

This is expected since confined MIM modes at higher energies sit where the dispersion is flatter (Supporting Information Figure S7) and thus tune less with a change in facet width.

Often stoichiometric films can only be deposited in this unstable transition mode at high deposition rates.