Sentence examples for modes are very from inspiring English sources

Consequently, their buckling modes are very different to those of supported beams.

The three modes are very close to each other in spirit, staining each other: one often hears a barely suppressed note of desperation in the praise, as if it were about to collapse back into plea or plaint.

This clearly shows the necessity of including static modes in the reduction basis and that nonlinear interactions between unstable modes are very difficult to represent with reduced bases.

It is also observed that shells having stiff central flat circular region show different harmonics in conical region for different modes of deformation and the values of critical pressure for different modes are very close to each other.

At low frequencies, torsional-like modes are very sensitive to the variation of prestress; in addition, the prestress configuration has little influence on propagating modes at mid-frequencies but some at high frequencies.

The calibrations of TE and CC modes are very similar and we have found only small differences with respect to ACIS gain, response, and integrated grade distribution, with CC faint mode versus CC graded mode choice resulting in less than 3% differences at the most.

The damping of wheel modes is very light so that the half power bandwidth is small, typically only a few Hz.

This state-vector formalism combined with Legendre polynomial expansion distinguished the adjacent dispersion mode clearly, even when the modes were very close.

Both sets of lower modes were very complex but the modal frequencies above n = 11 were found to fit a modified form of Chladni's law.

Using TSMC CMOS 180 nm process for the design and simulation, our test results show that the proposed switchable pin can well compensate voltage loss in chip multiprocessor, and transfer time of two modes is very short.

Accurate prediction of the structural capacity of lattice towers under different failure modes is very important for accurate assessment of the reliability of transmission lines and power grids, and for design of efficient failure containment measures.