Sentence examples for modes are close from inspiring English sources

The TEM01 and TEM10 modes are close to each other in frequency and about 1.2 GHz from the fundamental TEM00 mode.

Specifically, under the condition given by this article, the horizontal section limit of offshore conventional drilling is 4318 m, while both the two limits of DGD modes are close to 4500 m; as a contrast, the limit of onshore drilling is 7157 m.

The pairwise joint modes are close to the marginal point estimates in Table 4.

Firstly, in this configuration the internal and external energy modes are closer to each other, resulting in a greater coupling between them, and consequently, both have some influence over the two hybridized modes.

In particular, it has been illustrated and discussed that action of white noise on chaotic vibrations implies quasi-periodicity, whereas the previously non-symmetric vibration modes are closer to symmetric ones.

The condition for such gains is that the outer metal layer has a thickness in the range of 5 to 10 nm; in this configuration the internal and external energy modes are closer, so that the interaction between them is greater and, consequently, both have some cross-influence over the hybridized modes.

The results indicate that when the ratio of the resonant frequencies of the first bending symmetric and anti-symmetric modes is close to two, and the excitation frequency is equal to the resonant frequency of the first symmetric mode, the contribution of the first anti-symmetric mode is significant, even though the curved panel and excitation are symmetrical.

The effects of the proposed guidance mode are close to that of 3DSGL despite its very simple form.

As shown in Figure 11, when there is no handoff, the TCP throughputs of all four protocols in RO mode are close to each other.

The results show that mode interaction may occur if the higher harmonics of a vibration mode are close to the natural frequency of a higher mode.

The measurement shows that the laser has two longitudinal modes very often, but with the change of laser length arising from the thermal expansion; when one of modes is closed to the central frequency in the gain profile, the third mode may also appear.