Sentence examples for modes an initial from inspiring English sources

Generation of putative binding modes: An initial binding mode for compound 1 was generated by manually docking the ligand into the ATP binding pocket of the TbGSK3 homology model with the requirement to establish hydrogen bonds to the hinge residues using Moloc.

This analysis showed that pattern evolution could be classified into four modes: Elongation mode: an initial spot with high activator concentrations continues to elongate to form stripes as the meristem grows (Fig. 2E and Movie S4).

Common to all three fracture modes is an initial unstable propagation phase following by a stable growth, with detrimental failure associated with severe damage to the top surface and/or delamination at the coating/substrate interface taking place at loads several times the fracture initiation loads.

For the sequenced-batch mode after an initial growth in batch mode 2 L (3 L) of the medium were removed and the bioreactor was fed with 2 L (3 L) of fresh medium containing sufficient glucose to provide a final concentration of 5 g/ L in the bioreactor.

The cell was operated in the batch reactor mode with an initial salt concentration of 1000 mg/L NaCl, a typical level of domestic wastewater.

In the proposed method, nonlinear sliding surfaces incorporating the system initial conditions and exponential functions, which guarantee the existence of sliding mode from an initial state are utilized and appropriate control inputs are designed.

In the inner-heating mode, during an initial stage of methane oxidation, complete oxidation of methane (COM) mainly happened on Ni, whereas partial oxidation of methane (POM) mainly occurred on Rh.

Identifying behavioral mode within the context of current management establishes the opportunity to quantitatively assign observed data to a defined mode as an initial analytical step.

This can be well described as, where Γ o is the linewidth of the optical mode at an initial point; L c is the critical phonon length; and a is the coefficient.

Propagation was performed in fed-batch mode after an initial batch culture.

For the GC/MS analysis, 10 μl of sample extract was injected into the PTV injector in split-vent mode at an initial temperature of 55°C for 0.5 min at a vent flow of 100 ml/min; the temperature was then ramped up at 600°C/min to 400°C with a 15 min static time.