Sentence examples for models of pore from inspiring English sources

Models of pore pressure distribution and seepage stresses under anisotropic seepage are established.

Herein, a toolkit of 3D analytical models of pore size distribution and electrolyte uptake expressed via wicking characteristics of AGM separators under unconfined and confined states is presented.

Three analytical models of pore compressibility were displayed to investigate the effects of pore geometry and rock elastic properties on pore compressibility.

In addition, the existing models of pore size distribution of cement-based materials has been reviewed and compared with test results in this investigation.

Generalized models of pore fouling based on the standard blocking or complete blocking mechanisms are derived to simulate filtration of solutions at different filter set-up configurations using filters of different filter areas and construction.

The latter result, which could neither be practically achieved in the controls nor expected based on current models of pore size distribution, demonstrated the greater openness of the pore structure of the bimodal material, which remarkably did not come at the expense of its mechanical properties.

We show that due to the additional gas adsorption at the pore edges the adsorbed gravimetric amount significantly increases (by a factor of two) with respect to models of pores with infinite graphene walls.

Finally, further developments that are needed for a full model of pore formation are discussed.

The behaviour is contrary to expectations of a dissolution model of pore formation.

Models used for the mechanistic modeling were the intra-particle model of pore diffusion and Bangham's model of film diffusion.

The model of pore occupancy leads to quite complex saturation-dependencies of the corresponding three-phase relative permeabilities.