Sentence examples for models for plastic from inspiring English sources

These effects will be discussed in the light of existing models for plastic deformation of thin films or fine grained metals.

A model for plastic flow generated by DAS inside grains is proposed.

Validations with data from several soils indicated that the approach offers consistent and accurate predictions of PCCs when used with Zapata's model for plastic soils and with the Mechanistic Empirical Pavement Design Guide (MEPDG) model for non-plastic soils.

Finally, the research findings are synthesized into a new model for plastic hinge length that allows for number of load cycle.

Evaluation of seismic performance of moment-resisting (MR) steel frames is usually carried out assuming the elastic-perfectly-plastic type of hysteresis model for plastic zones (in particular for beam-to-column connections).

The creep-fatigue analysis is implemented using the following material models: 1) Ramberg Osgood model for plastic strains under saturated cyclic conditions; 2) power-law model in "time hardening" form for creep strains during primary creep stage.

Here we build on the rich history of Drosophila melanogaster as a model for plastic recombination and specifically test whether increased exposure to stress yields an increasing and upwards perturbation in recombination frequency.

The predictions provided by the codes and guideline models clearly overestimated the experimental results, which suggests the need to review the constitutive models used for plastic fibre-reinforced concrete.

Micromechanical models for the plastic expansion process are developed and used to identify the practical porosity limits in this entrapped gas expansion approach.

Additionally, existing regression models for Bingham plastic (BP) and power law (PL) fluids were modified based on the exact numerical solutions in concentric annuli with OEP.

We start by introducing six numerical algorithms for the modeling of the principal damage pattern, glass-ply cracking, followed by the introduction of material models for the plastic interlayer, PVB, and then address three numerical techniques for the adhesion modeling.