Sentence examples for models calculated with from inspiring English sources
Models calculated with this new equivalent embedded reinforcement stress-strain law showed accurate predictions for crack openings at construction joints for different types of concrete.
The predictability of multivariate calibration models, calculated with offline near-infrared spectroscopy (NIRS), assessing impact of magnesium stearate (MgSt) fraction, blending time, and compression force on the tablet breaking force (TBF) of SPRESS® B820 was statistically compared.
The wind forces on the 5 truss models calculated with this method compare very well to the results from wind tunnel tests and the difference with experimental tests is similar or smaller to the one obtained with the various design documents.
We present new results fitting Chandra ACIS and LETG/HRC-S spectra of the Cas A X-ray point source (XPS) and the isolated neutron star RX J1856.5-3754 to H, H He, Si ash, and Fe atmosphere models calculated with our compact atmosphere model code.
RMSE of LibSVM models calculated with different sets of descriptors.
Upper plots correspond to GP models calculated with the radial kernel while the bottom plots refer to GP models with the normalized polynomial (NP) kernel.
The causal relationships between these three constructs have been tested via a structural equation model calculated with the linear structural relationship method.
Speciation modeling (calculated with the help of PHREEQC code) result for selected minerals in specified water samples is shown in Table 2.
The causal relationships between these three constructs have been tested via a structural equation model calculated with the linear structural relationship method.1.1
The spectrum of the noisy synthetic audio signal defined before, downsampled with a factor (obtained from (59) with and ), is shown in Figure 8(a), and the PEF pole-zero plot and magnitude response, resulting from using a th-order SLP model, calculated with the autocorrelation method, are plotted on the downsampled frequency scale in Figures 8(b) and 8(c).
From the analysis conducted it is concluded that the single-zone model calculates with reasonable accuracy the in-cylinder pressure, while it rather underestimates the peak in-cylinder mean gas temperature near the top dead center (TDC).
