Sentence examples for modelling and numerical from inspiring English sources

Four typical types of section profiles have been selected for modelling and numerical analysis.

The use of moment closures for the prediction of continuum and moderately non-equilibrium flows offers modelling and numerical advantages over other methods.

The present article addresses this aspect of SPD and provides a commented exposé of a modelling and numerical simulation toolkit that has been, or can potentially be, applied in the context of severe plastic deformation.

Major emphasis is placed on the unique characteristics and mechanisms of Lamb waves in laminated composites; approaches in wave mode selection, generation and collection; modelling and numerical simulation techniques; signal processing and identification algorithms; and sensor network technology for practical utility.

Broadly speaking, maths degrees should give you the basic ideas of pure mathematics (linear algebra, geometry etc), applied mathematics (calculus, mathematical methods, modelling and numerical analysis), and statistics (including probability and operational research).

Concept-conforming modelling and numerical stress and strain analysis are relevant modules of the procedure.

When the system starts, the maximal relative error is high because the system is hardly heated up (exact values close to zero) and the thermal parts are dominated by modelling error and numerical error.

Since then, a lot of scientists have conducted rock physical modelling experiment and numerical simulation studies (Haln and Monger 1990; Wozinak et al. 1997), these basically figure out: when the gas was injected rapidly into the storage, it would cause a series of reactions, such as the instigation of the Jamin effect, flow-around, water-locking, gas-locking, and emptying (Kurihara et al. 2000).

Finally, the modelling and associated numerical simulations are used the help process design.

Having said that, however, one should bear in mind that the enhanced determinist approaches, in nature, are based on analytical modelling of wave propagations and numerical modelling (element-meshing) of dynamic deformations.

The design model is based on the experimental results and numerical modelling described in Part I of this paper (Pertold J, Xiao R, Wald F. Embedded column base Part I. Experiment and numerical simulation. Journal of Construction Steel Research).