Three different simulated mediums with permeabilities of 204, 102 and 51 Darcy; two heavy oils with viscosities of 14,500 mPa s and 20,000 mPa s; and two physical reservoir model heights of 25 and 45 cm were considered.
In the proposed model, height of destressed zone above the mined panel, total longwall mining-induced stress, abutment angle, induced vertical stress, and coefficient of stress concentration over neighboring gates and intervening pillars are calculated.
There was a rapid temperature drop away from the surface, with the temperature distribution reaching near ambient conditions within one model height downstream of the heated face for Gr/Re2∼1.6.
Instead of widely used Gaussian distribution of surface heights, the Weibull distribution was used here to model asperity heights distribution of the counter-surface.
However, this was carried out only for linear mixed models (height) as interpretations of DIC in generalized linear mixed models with latent variables may not be clear.
In two-dimensional models, the height of the fluid is taken into account and in the three-dimensional models the width of the fluid and the width of the cochlear partition are additionally included.
This study used regression analysis to model the height increment of spruce understorey as a function of seedling height, site characteristics and canopy structure.
A second multiple linear regression model was run for BP- and FPG-changes that includes in a addition to the first model the height of BP (WHO-grade) or FPG (< 11 mmol/l versus ≥ 11 mmol/l) at the start of the treatment, the number of consecutive follow-up visits and the variable pharmacological versus non-pharmacological treatment.
The main parameters in designing a channel model are the heights of transmit and receive antennas, the position of the surroundings relative to the antennas, the Doppler spectrum as well as the parameters intended for calculation.
In our model, the height of the brush decreases from approximately 12 to 2.75 nm (23% of original height) when the temperature is increased from room temperature to 375 K, and variations in grafting density in the range of that used experimentally result in only minor changes in contraction (Supplementary Figure 16a).
