To get an added value, after these two model are merged, Principle of Hoffman (2003) is used to give a better and upgraded model.
The TLS 3D model was merged with the GB-InSAR data obtaining a 3D GB-InSAR cumulative displacement map, which allowed to read detected LOS displacements directly on the observed scenario 3D representation, and therefore both to better localize the most critical areas, and compare the different techniques displacement data (Fig. 10).
DOI: http://dx.doi.org/10.7554/eLife.09560.026 After the Sts 19 model was merged with the DH3/DH4 model, the endocranial surface was extracted and reconstructed as described above.
In these cases, the length of the polyA tract was left unchanged but the gene models were merged or extended, resulting in a DNA sequence that codes for a gene in two reading frames.
In a subsequent merging step, predicted and existing gene models were merged into a hybrid gene set, retaining predictions that (a) did not overlap with existing gene models or (b) showed a PID improvement of at least 5% over overlapping existing gene models.
To address small sample issues in Project II, the 7 original models in the framework were merged into 3 groups, labelled A, B, and C. Grouping of the models was based on conceptual similarities between models [ 6].
This joint model is merging different models, respectively, characterizing the different components of the system (source, source coder, channel coder, and channel), and is enabled by a set of well-defined simplifying assumptions.
In a next phase, both models are merged to yield an integrated city model or generalized DSM.
The two limiting models are merged into each other by allowing key parameters to vary continuously with the superficial velocity, U, using probabilistic averaging.
Both models are merged in order to develop a method for data evaluation in office buildings with night ventilation and to provide a simple model for integration in a building management system.
