Sentence examples for model very low from inspiring English sources

Open cell rigid foam of density 0.09 g.cm-3 was used to model very low density cancellous bone.

In the multivariate model, very low and low birth weight were associated with an increased risk of type 2 diabetes relative to normal birth weight.

The 0.09 g.cm-3 PU foam, used to model very low density bone in this study, is much weaker than the OP bone investigated by Li and Aspden [ 14].

The limited retardation (R ≈ 1) interpreted using the model, very low estimated Kd obtained with the different methods, and the minimal retention of 99mTc in the sand at the end of the experiments imply closely conservative transport of 99mTc through Ottawa sand.

Due to the lack of Tremor for the PSP-group, equal factor correlation matrices across groups did not produce an acceptable model (Model PP3: chi-square = 2376, df = 972, RMSEA = 0.081, falling outside the confidence interval of the baseline model; very low CFI (0.89) and TLI (0.90), and a disastrous St.RMR of 0.22).

For the CX3CR1 V249I polymorphism, GRADE suggested that the quality of the evidence was moderate in recessive model, codominant model, and additive model, low in dominant model, and very low in allelic model (Table S1).

FCP also displays excellent cell permeability in HeLa cell model and very low cytotoxicity to HEK-293 cell model.

For example, the readmission rate for the 231 patients predicted to be in the top 20 % by the e-model and bottom 20%% in the CMS model was high (22.5 %), whereas the readmission rate for the 81 patients predicted to be in the bottom 20 % by the e-model and top 20%% by the CMS model was very low (3.7 %).

For some of the SNPs the rank based on the 1-SNP model is very low compared to the score of the corresponding 2-SNP model which implies that these SNPS would not have been identified by univariate analysis.

Analyses and results demonstrate that the search failure rate of proposed model is very low and demands little system resources.

The ASHRAE, 2007 model predicted very low dilutions for the isolated building, making it necessary to re-visit its formulations.