Sentence examples for model the saturation from inspiring English sources

To model the saturation and nonsaturation traffic conditions.

In the Langmuir model, the saturation capacity of the adsorbent (qmax) is equal to the saturation of the identical sites.

Therefore, using the developed simulation model the saturation flows at signalised intersections are investigated in an aggregate form of vehicles per hour.

(i) To apply the geometrically increasing distribution as IB to IEEE 802.15.3 MAC.   (ii) To introduce Markov Chains for BEB and IB in WPAN MAC.   (iii) To model the saturation and nonsaturation traffic conditions.

In addition, in light of the Monod model, the saturation concentration (Ks) and the maximal specific substrate removal rate constant (Rm) were determined to be 0.107 g/L and 0.952 g N/g MLVSS/d, respectively.

The overall parity between measured parameters and those predicted by the 10 QS/RC parameters was very good, and allowed for 88% reduction in the number of parameters needed to model the saturation kinetics of polynuclear aromatic hydrocarbons.

It means the system model changes from the non-saturation model to the saturation model; this model is called as the time-saturation model.

As introduced in Section 4, the Morse potential models the saturation of link cost/energy when reaching physical constraints (see Figure 4).

In the model presented, the saturation velocity does not sensitively depend upon the momentum-randomizing scattering events that control the mobility.

Experimental results showing the effect of LMF on the sensor temperature are given, as are results from a thermal model of the saturation regime.

According to the Zn2+ and H2S concentrations predicted by MINEQL+ [29] for the ZnS-CYS model solutions, the saturation index for ZnS s) (i.e., log Q/Ks, ZnS) was equal to +5.5, demonstrating oversaturated conditions in the model experiments.