Sentence examples for model the flame from inspiring English sources

In the non-dimensional model, the flame base stabilization zone structure is resolved.

Three different mechanisms have been tested to model the flame, with good agreement between calculated and experimental results.

Results show that it is paramount to specify the inlet location at a certain distance upstream the burner exit to model the flame attachment phenomenon.

With the CD model, the flame becomes attached when either the value of Cϕ is increased to 3 or the pilot flame thermal power is increased by a factor of 1.5.

Nevertheless, in the CFD model the flame is quenched at near 370 crank angle degrees (Fig. 6), then a small amount of heat is gradually released from 370 to 440 crank angle degrees.

Three recently developed chemical kinetic models were utilized to model the flames and thus investigate the kinetic pathways controlling the formation of C2H4 and two key soot precursors, namely C2H2 and C3H3, aiming to provide insight into the experimentally observed differences in the sooting propensity among the flames of the various fuels that were considered.

The governing equation for energy contains a compressible source term that models the flame.

For two burners with spacing higher than zero, by assuming that the flame radiative fraction of propane is 0.3 and the flame emissivity is equal to that of the single flame, the flame radiative heat fluxes received by external targets are calculated by modeling the flame shapes as two right or tilted cuboids.

The finding is clarified in the framework of an acoustic network model, where the flame is described by an acoustic scattering matrix.

Numerical simulation shows that the expanded kinetic model predicted the flame speeds to within 3 cm/s of the measured values.

After the evaluation of model by the flame front propagation and associated temperature, data is used in a second model.