Sentence examples for model tests carried from inspiring English sources

This paper presents the results and conclusions obtained from the physical model tests carried out with four different designs of floating breakwaters.

Physical model tests, carried out in the wave basin of the Hydraulics Laboratory of the Hydraulics, Water Resources and Environment Division, Civil Engineering Department, have been used to study the hydraulic processes related to wave reflection.

The tool development and validation were supported by experimental data from physical model tests carried out in a wave flume at the Portuguese National Laboratory for Civil Engineering LNECCivil Engineering LNEC

Wave loadings and average wave overtopping rate at the rear side of the rubble mound breakwater and in the front reservoir are discussed on the basis of physical 2-D model tests carried out at Aalborg University (DK).

In this work the radial load experienced by the bearing strut of a twin screw configuration is experimentally investigated by free running model tests carried out at the CNR-INSEAN outdoor maneuvering basin.

The ANN model is trained and, eventually, validated based on an extensive campaign of physical model tests carried out under different wave conditions, tidal levels and values of the damping coefficient, representing turbines of different specifications.

Subsequent phylogenetic analysis was carried using PhyloBayes v3.3 (Lartillot et al., 2009) under the LG + CAT model until a splits frequency of 0.1 and 100 sampling points was achieved, and PhyML v3.0, with model testing carried out using ProtTest v3.3.

The proportional hazards assumption was tested with the estat phtest command in Stata and was not violated in any model (test carried out with the detail option in Stata to examine the proportional hazards assumption for each predictor as well as to carry out the global test).

First, model tests were carried out on two specimens with different shear spans to investigate the mechanical behavior, including the load-carrying capacity, failure modes, flexural and shear stress distribution, and development of concrete cracking.

This reference propeller was optimized using the new design procedure and model tests were carried out.

Later, model tests were carried out to validate the numerical results.