The cores were drilled from upper, middle and lower layers of the field MOCK-UP model specimen, and the appearance was noted.
In particular, stress and strain fields in reactor pressure vessels of WWER-440 and WWER-1000 thick, thick plates and model specimens were determined.
To avoid data corruption and/or misinterpretation due to environmental conditions or aberrant/differing age of skin lesions, conditions for the biological model, specimen collection, and preparation were highly standardized.
Model specimens were tested by pneumatic cycles with and without synchronized bending.
Pseudo-static tests were conducted on the model specimens to investigate their seismic performance, the yielding mechanism and the damage mode.
Copper solder copper double cantilever beam (DCB) model specimens were prepared using SAC305 solder at cooling rates and times above liquidus typical of actual ball grid arrays (BGAs).
Fabrication of artificial (physical) model specimens in laboratory can be used to overcome this difficulty and to study the mechanical behavior of bimrocks.
The tensile failure results of the model specimens were compared with AE results in terms of amplitude, energy and counts.
Therefore, we aimed to characterize the immunocyte composition of the metastatic niche in the murine model specimens.
Through the model, specimen in rutting test and actual pavement are connected.
