Sentence examples for model set with from inspiring English sources

The model, set with a pH of 6.3, correctly simulated the initial aqueous concentration of As V) corresponding to 5% of total As, i.e. a sorbed fraction of 95%.

Through Laplace transformation, we can get the model set with no-flow tip of the fracture and constant production rate at the bottom hole: left{ {begin{array}{lll} {frac{{partial^{2} bar{m}_{text{fD}} }}{{partial y_{text{D}}^{2} }} + frac{2}{{C_{text{FD}} }}left.

Through Laplace transformation, we can get the model set with no-flow tip of the fracture and constant production rate at the bottom hole: left{ {begin{array}{*{20}l} {frac{{partial^{2} overline{{m_{text{fD}} }} }}{{partial y_{text{D}}^{2} }} + frac{2}{{C_{text{FD}} }}left.

In recent work on comparing different modeling hypotheses, we validated a two-site reactive model set with adjusted chemical kinetic constant values by fitting the 2005 Zn and Pb concentration profiles in soils, with estimated 1901 1963 airborne Zn and Pb loads (Mallmann et al., 2012a).

We note that the total number of contacts did not necessarily indicate higher structural quality: native (f̅ = 1) structures had 136055 backbone contacts while the misfolded model set with f̅ = 0.68 had a larger number, 154994.

The HMMs were trained using SONIC's decision-tree HMM trainer [32, 33] resulting in a model set with approximately 10 K total Gaussians.

The results were similar for the SEM and scaled NLMM in the logistic model setting, with both accurately estimating the effect of the time-dependent predictor on the longitudinal binary outcome.

By extending the power transformation into linear mixed model setting with NDNQI examples, we found limited difference from subsequent test of structural effects regardless of whether such structure is included or omitted during the parameter estimation for transformation.

In our simulations, this is done using SRmapqtl with model set to two (the model with forward and backward selection in stepwise regression) in the QTL Cartographer software [18].

To print you simply download a model, set up Cura with the OverLord's specific site and height, and then run the slicer.

Specifically, using the QTL Cartographer software, the Zmapqtl function was used with the model set to six (the model with up to five background markers used as covariates and a 10 cM blockout window around the test position) [18].