Sentence examples for model predictions relative from inspiring English sources

The predictive logscore results show that MLBMA generally outperforms the best model, suggesting that using MLBMA is a sound strategy to achieve more robust model predictions relative to a single model.

Our expanded model predictions had relative RMS errors within this range (9-21%).

The model prediction accuracy relative to FEM simulations is found to be satisfactory, with errors of less than 10%.

Thirdly, the model predictions will show relative, and not absolute, activation levels.

This observation, along with model predictions of the relative frequency and perimeter length associated with E-cadherin mediated cell contact in the different environments (as shown in figure 7), indicates that at high density, cells in low calcium are still able to migrate and make contacts that are predominantly transient in nature (as shown in additional file 2).

The two objectives of the present paper are: (i) to examine the effect of the inhomogeneous mixing model on the autoignition predictions relative to the results obtained using homogeneous mixing models and (ii) to see if the magnitude of the change can explain the discrepancy between the predictions of ignition delay previously obtained with homogeneous mixing models and the experimental data.

In this paper we compare model predictions and experimental results of relative humidity and solution compositions for saturated NaCl NaNO3 H2O, KNO3 NaNO3 H2O, and NaCl KNO3 H2O systems from 90 to 120°C.

Figure 8 Model predictions of brine (a) % relative humidity and (b) solution composition as a function of temperature at the deliquescence point for a NaCl NaNO3 KNO3 mineral assemblage (Ref. 8).

The experimental verifications substantiated the model predictions by showing a maximum relative surfactin concentration of 58 CMC−1, which was found to be equivalent to about 1.3 g L−1 crude surfactin as estimated gravimetrically, thereby resulting in an improved production.

A remarkably good agreement between model predictions and direct three-phase relative permeability measurements from the literature is observed when model parameters are estimated solely on the basis of two-phase information.

The effect of mechanical shear and/or greater bed height was to significantly enhance thickener performance relative to model predictions (as measured by underflow density or maximum solids flux density achievable for a nominated underflow density).