Sentence examples for model calculation to from inspiring English sources

An original model calculation to take into account these different seawater conditions has been developed based on the classical carbonate system equilibrium allowing production of a complete chemical and mass balance of the entire system including the chemicals dosing rate based on raw water characteristics.

This paper reports an excessive overlap avoided behavior rule model based on the existing social force model, through improving the driving force, attractiveness and direction influence in the model parameters, and rectangular scope was also introduced in model calculation to reduce the computing time.

Based on our findings, we performed a model calculation to estimate how elastography could affect the proceedings in screening populations.

Furthermore, we performed a model calculation to determine how elastography could affect the proceedings in population screening with a given prevalence of BI-RADS®-US 3 lesions.

Furthermore, we analyzed the false-negative and false-positive cases and performed a model calculation to determine how elastography could affect the proceedings in population screening.

Again we use the ratio of the theoretical approach to the model calculation to derive the discontinuity correction factor: (10) ξ dif (i ) = N dir (i ) N dif 3 D (i ).

Using this minimalist landscape, we perform model calculations to illustrate the relative impact of activation barriers and entropy on glass relaxation behavior.

This data set is fitted with model calculations to extract the size distribution, shape and the refractive index of the aerosols suspended in the atmosphere.

Periodic slabs with surface areas of 13.86 Å2 (1 × 1) and 124.76 Å2 (3 × 3) were used for the surface model calculations to test the effect of increasing the surface area on the predicted structures.

We compare the measurements to model calculations to demonstrate that the reflectivity can be well described by the intended power law distribution of the bilayer thicknesses, and that the coatings are uniform at the 5% level over the mirror surface.

This paper describes the improved model and compares model calculations to segregation data from seven alloys irradiated at temperatures between 200 and 600°C and to doses from 0.1 to 3.0 dpa.