Sentence examples for model and peak from inspiring English sources

The next cycle will begin 6 to 12 months later than average, in late 2007 or early 2008, according to the model, and peak in 2012.

Plasma EPO profiles were well described by our model, and peak concentrations were captured at both doses.

To exclude the possibility that TileProbe's observed advantage was due to differences in implementing the MAT model and peak detection algorithm, the MAT curves shown in Figure 2 were based on peak detection results obtained using the MAT we implemented in TileProbe.

Compared with PCT, presepsin increases at 2 hours post-infection in the cecal ligation and puncture (CLP) sepsis model and peaks at 3 hours [ 29].

The application of these excitation and averaging methods is discussed relative to lightly or heavily damped systems, systems with small non-linearities, FRF models, and peak to RMS (crest factor) as well as signal-to-noise ratio (SNR) issues.

The values was significantly higher in EA group after 6 h time phase when compared with model group, and peak values were reached at 12 and 24 h in model and EA group, respectively.

Comparison reveals that the shapes of the normal stress distribution in both models are similar, although the peak tension stress using the discrete connector model is greater than that in the fully supported model, and the peak compression stress in the former model is smaller than that in the latter model.

Pretreatment with an inhibitor of endogenous NO synthase (NG-nitro-L-arginine methyl ester) resulted in increased pulmonary capillary pressure and postcapillary pulmonary vascular resistance in the rapid-injury model and increased peak Ppa, pulmonary capillary pressure, and pulmonary vascular resistance in the gradual-injury model.

The framework of IRP considering IL and SL is established, together with a traditional planning model and pure peak clipping model for comparisons.

In Table 6, the results for the traditional planning model, IRP model, and pure peak clipping model under the load data are depicted in Case 1, Case 2 and Case 3, respectively.

And the overall planning cost for Case 2 is less than that for Case 3. It clearly demonstrates that IRP considering IL and SL can achieve more economic benefits than the traditional planning model and pure peak clipping model.