Sentence examples for model allows estimating from inspiring English sources

A simple linear dynamic model allows estimating temperature profiles at stationary state, and temperature dynamics in the transient state when VOC concentration varies.

Focusing on the analysis of determinants of behaviour unemployed versus inactive, for the purposes of limiting the risk of selection bias, a bivariate probit model allows estimating the probability of being actively searching for a job upon the unemployed condition (Castellano et al. 2013).

Additionally, this model allows estimating the effects of operational conditions such as reflux ratio and feed condition on the EG. The results obtained show that mixing effects at the feeding points (hydrated ethanol and separation agent) and interface mass transfer are the main sources of EG with 55% and 41% of total EG, respectively.

This model allows estimating the proportion of sites evolving at different ω rates in both clades, and is tested against model M1a using an LRT with 3 df.

Since the Rasch model allows estimating the parameters by using all the available information based on the likelihood, we might expect a better performance of IRT as compared to CTT in this framework.

This model allows estimating currently unknown pivotal biomedical parameters, including the duration of exogenous boosting at 2 years, with a peak threefold to fourfold increase of VZV-CMI; the VZV weekly reactivation probability at 5% and VZV subclinical reactivation having no effect on VZV-CMI.

Additionally, application of the Rice and Roth model allowed estimating the temperature dependence of proton number and their mobility in CS-acetate films.

The general formulation of the kinetic model allowed estimating the contribution of each adsorption rate controlling parameter and the effect exerted by the main fluid dynamic parameters, hence representing a fundamental tool for the design and optimization of an adsorption column.

Fitting the growth kinetics with this model allowed estimating K and r (Fig 1B).

Comparison of the distribution of defects observed in grown ingots with the results of modelling allows estimating λl as lying in the range 3.50 3.75 W m−1 K−1.

Emissions-based atmospheric dispersion modeling allows estimating NH3 concentrations in a region regardless of the existence of an air quality station.