Sentence examples for mode volume of from inspiring English sources

This equation is a widely used measure for the mode volume of plasmonic cavities in the literature57,58,59.

This geometry results in a mode volume of only V = 330 fL or as little as 88λ3, while achieving an optical quality factor of Q = (1.1 ± 0.05) × 107.

We built large arrays of microcavities with finesse values greater than F = 500,000 and a mode volume of 330 fL at wavelengths near 1550 nm.

Etched to an almost perfect parabolic shape with a surface roughness on the level of 2 Å and coated to a finesse exceeding F = 500,000, these new devices can have lengths below 17 µm, confining the photons to 5 µm waists in a mode volume of 88λ3.

The microcavity quality factor and coupling efficiency can be adjusted through changing the space and the number of cylinders between the point defect and the waveguide, and the oscillation frequency can be tuned by changing the mode volume of the point defect.

Consequently, the mode volume of nanocavity mode becomes large, as shown in Figure 2c.

Figure 3 The optical properties of the SPP modes with m = 1, 2, and 3. (a) The resonant wavelengths and mode volumes are plotted as a function of L. An extremely small mode volume on the order of 10-5 μm3 results.

The TM-like WG and radial SPP modes have subwavelength mode volumes of 0.56 (λ/2n)3 and 0.65 (λ/2n)3, respectively, which are smaller than the diffraction limit of light.

In addition, extremely small mode volumes on the order of 10-5 μm3 were calculated (right axis, Figure 3(a)).

Furthermore, we calculate the effective mode volume Vm of the two SRR modes and the fraction η of QDs located in the mode volume, hence, coupled to the metamaterial by evaluating the mode-volume integral47,48 of a single SRR (see Methods).

While the optical mode volume Vm of the RR can fundamentally scale with Vm ~ rα, where α = 1, 2, or 3 depending on how many dimensions are being scaled, fabrication and integration constraints render quadratic and cubic scaling impractical due to mode matching incompatibility issues such as multi vs. single mode ring-to-bus coupling.