Sentence examples similar to mode using single from inspiring English sources

Analytes were detected in negative ionization mode using single-reaction monitoring (SRM) on a Quattro triple-quadruple mass spectrometer (Waters) with a cone voltage of 15 V and a capillary voltage of 3.0 kV.

The planar slip character observed was found to prevail under all test conditions applied and leads to a cyclic stress strain curve, which is rather independent of the testing mode used (single step test, multiple step test, incremental step test).

The AFM was operated in Tapping Mode use single crystal silicon tips with nominal radius of curvature 5 10 nm and cantilever resonance frequency in the range of 200 300 kHz.

the SVM-SGD algorithm deals with the imbalanced datasets for building binary classifiers, the SVM-SGD algorithms also takes very long time to train very large number of binary classifiers in sequential mode using a single processor.

A new method for the analysis of spatial and angular characteristics of the cosmic ray muon flux registered in the hodoscopic mode using a single setup – the muon hodoscope – is presented.

However, the multiclass SVM-SGD algorithm using one-versus-all leads to the two problems: 1. the SVM-SGD algorithm deals with the imbalanced datasets for building binary classifiers,   2. the SVM-SGD algorithms also takes very long time to train very large number of binary classifiers in sequential mode using a single processor.

The alkaline cyanide feed solution containing Au(I) was passed through the tube side, and pseudo-emulsions of LIX-79/n-heptane and NaOH were passed through the shell side in counter-current mode, using a single microporous hydrophobic polypropylene hollow-fiber contactor for extraction and stripping.

It is also proved that the tests to assess the improvements obtained with design changes could not have been completed in the steady-state mode using a single engine because of the short life cycle of racing engines due to wearing, which would have altered the comparisons.

Experimental results showed that it was feasible to describe monotonic and cyclic tests of stress-controlled mode using one single damage accumulation model based on stress time path, which makes it possible to reduce the number of specimens tested and time-consuming fatigue tests are no longer necessary, since the same information can be obtained from monotonic test data without loss of accuracy.

Confocal analysis was performed using a Zeiss LSM-510 Meta laser scanning microscope with 63X oil immersion lens in a multi-track mode using a single or dual excitation (488 nm for GFP and/or 543 nm for mCherry).

Transmission scans for attenuation and scatter correction were routinely obtained with each scan in two-dimensional mode using a single point Cs source.