Sentence examples for mode the heat from inspiring English sources

For GHE working in the heating mode, the heat extraction by GHE increases with decreasing fluid temperature at the inlet.

When operating in heat boiler mode, the heat production is limited by its lower (q_{g}^{mathrm {min}}) and upper (q_{g}^{mathrm {max}}) limits (9).

In this operation mode, the heat flux was linearly increased to a maximum of 54 W/cm2 at approximately 8 °C wall superheat temperature, corresponding to a heat transfer coefficient of approximately 62 KW/m2 K.

During the operation in the cooling mode, the heat extraction from the condenser of the heat pump was divided: part was rejected to the soil while another was used to reheat the air in AHUs.

In the cooling mode, the heat extraction from the condenser of the heat pump was divided: part of it was rejected to the soil while the rest was used to reheat the air in air handling units.

Based upon the measurements made in the heating mode, the heat extraction rate from the soil, with an average thermal diffusivity of 0.00375 m2/h, was found to be, on average, 11 W/m of bore depth, while the required borehole length in meter per kW of heating capacity was obtained as 14.7.

During DCMS mode the heating is not substantial but situation changes radically in HiPIMS mode.

The heating COP values in single stage mode ranged from 1.5 to 3.05, while in cascade mode, the heating COP values ranged from 1.74 to 2.55.

The results show that when the ambient temperature was −15 °C, compared to the single air heat source mode, the dual heat source mode increased 62% in heat capacity and 59% in COP; when the temperature difference of combined heat transfer was 5 °C, compared to the single air heat source mode, the dual heat source mode increased 51% in heat capacity and 49% in COP.

In the considered heat engine model, heat transfer from the hot reservoir is assumed to be radiation mode and the heat transfer to the cold reservoir is assumed to be convection mode.

In heating mode, the system heating capacity ranges between 165.6 W/m2 and 343 W/m2 and the corresponding system COP ranges between 1.51 and 1.8 under the working current from 2 A to 3 A.