Sentence examples for mode switches from from inspiring English sources

Test results indicated that the ultimate pullout strength increases and the failure mode switches from debonding to FRP rupture as the twisting moment increases.

For the three catalysts examined, it was shown that the growth mode switches from "tip-growth" for large particles (>>5 nm) to "base-growth" for smaller ones (<5 nm).

Indeed, above a certain critical thickness, the growth mode switches from the conventional layer-by-layer (i.e., two-dimensional, 2D) to a 3D growth mode due to the accumulation of the elastic energy in the strained layer that, first, partially relaxes by spontaneously nucleating small islands of strained material and, later, by creating misfit dislocations.

Remark: Based on the explicit results presented above, it is apparent that the probability that the sensor is in sleep mode is not equal to β / α + β, and the probability that the sensor in active mode is not equal to α / α + β, since the sensor node has to relay all data packets in the node when the sensor's mode switches from phase R to phase N.

Figure 3 Node N switches from MODE 1 to MODE 3. In case a node switches from MODE 1 to MODE 2 the same actions will be taken as in the case of a mode switch from MODE 1 to MODE 3, except for two differences.

In case a node switches from MODE 2 to MODE 1, almost the same actions will be taken as in the case of a mode switch from MODE 3 to MODE 1. First, the node will convert all its MODE 2 entries that are in use to MODE 1 entries.

Microscopic observations from transmission electron microscopy indicated that the deformation mode switched from dislocation motion to stacking fault (SF) formation with increasing γ′ content.

Flow mode switching from a fully saturated flow to a thin film flow can also be observed in the fracture junction.

The sensing properties of fabricated sensor exposed to dilute NO2 were investigated in a dynamic mode switching from air to the specific concentration of the target gas and again back to the base air in each cycle.

As there is only one direct successor of mode A in the spanning tree, the FindMappingMin procedure is executed for mode B. In this procedure, a Pareto frontier between schedulable mappings in mode B minimizing energy dissipation in B and the amount of data to be transferred during mode switching from A to B is determined.

During development, neurons modify their axon growth mode switching from an elongating phase, in which the main axon stem reaches the target territory through growth cone-driven extension, to an arborising phase, when the terminal arbour is formed to establish synaptic connections.