Sentence examples for mode propagating in from inspiring English sources
On the other hand, energy of the TM mode propagating in the x-direction is stored comparably in both, Ex component parallel to the mode propagation direction and Ez component perpendicular to the sample plane.
In case of the mode propagating in the x-direction, it is Ey component.
Stationary-phase method is used to calculate the GH shifts for different guided mode propagating in the waveguide, and simulation results show that the increase of the upper-cladding metal layer reduces the GH shift and the critical incident angle.
The main principle of operation of this device is based on high efficiency energy transfer between a p-polarized guided mode propagating in a waveguide layer of the structure and the SPP propagating in the opposite direction in a metal layer separated from the waveguide layer by a dielectric buffer.
Then the beam quality factors Mx2 and My2 of TE00 mode propagating in the laser are calculated, and the emphasis is laid on the variational relation between the horizontal beam quality factor My2 of TE00 mode and the active layer width W. The results show that My2 fluctuates with the active layer width W, which are useful for the proper design of the active layer width.
In a representative case the amplitude of a high order mode propagating upstream along a slowly varying elliptical duct is seen to be significantly lower than that of the equivalent mode propagating in a circular duct of the same cross-sectional area.
When a transverse electric (TE) or a transverse magnetic (TM) polarised waveguide mode propagates in the waveguide slab, its energy corresponds to a propagation constant βp defined by30 with g describing the location of the Fourier components.
In this fiber, fundamental mode propagates in an acceptable loss, while the HOMs decay rapidly.
These structural modifications are realised by altering the refractive index of certain high index inclusions in the photonic crystal cladding resulting in mode coupling between the core mode and the mode propagated in the modified index region.
The coupling length in a dual DLSPPW coupler can be considered as a symmetric and an anti-symmetric modes propagating in the coupler with different propagation constants β+ and β-[20].
The sharp resonances at approximately 1.5 eV, 1.6 eV, 1.75 eV, and 1.85 eV are due to TE and TM waveguide modes propagating in the waveguide layer with a propagation constant equal to the inner ring of the Fourier components [see inner dashed circle in Fig. 2(b)] as well as those with a propagation constant equal to the outer ring of the Fourier components [see central dashed circle in Fig. 2(b)].
