Sentence examples for mode of stress from inspiring English sources

The Australian-born engineer Anthony George Maldon Michell developed a mode of stress analysis for bones in 1908.

The physical and mechanical properties of fibres/polymer composites depend primarily on the properties of the combined materials, the surface of the fibres, the interface between the two components as well as the mode of stress transfer at the interface.

Fibers with dense hierarchical microtwin structures having spatial dimensions of ∼10 nm showed an additional mode of stress accommodation as evidenced by a larger strain accumulation and greater anelastic response relative to fibers with conventional twin structures consisting primarily of 90° and 180° tetragonal ferroelectric ferroelastic domains.

The maximum strain energy theory of failure of an elastic material under this mode of stress is used to set up a relationship between the stable length of hyphae and some of the physical parameters affecting it, including the mean energy dissipation rate in the bioreactor.

The mode of stress applied is flexure, and the fixture configuration is a single cantilever beam.

The mode of stress loading, which includes the main stresses of constant stress, step stress, and progressive stress.

The experimental investigation gives prominence to the different structural behavior of this kind of column in the case of the load applied only to the composed web – two of the four channels – and the case of the load applied to the overall cross-section, aspect that strongly influences the transfer mode of stresses.

In particular, the silk fibroin / collagen hydrogels are highly elastic, exhibiting excellent resistance to permanent deformation under different modes of stress; without being collapsed or water-squeezed out (vs. not possible in individual proteins) – which results from the mechanical synergism of interpenetrating networks of both proteins.

However, as the performances of SSALT and RCSMT are sometimes superior to that of CSALT [80, 82, 83, 108], at least in theory, it is possible that the modes of stress loading can still be optimized, but no theoretical research on this topic has been produced.

Such factors would introduce different modes of stress application (e.g., compressive, tensile, or shear) to the cancer cells, which may or may not cause cancer cell death.

Squeezing out of water through channels in compressed biofilms may also constitute the reason as to why biofilm elasticity and viscosity vary when derived in different modes of stress application.