Sentence examples for mode of sample from inspiring English sources

The current study investigated whether the mode of delivery and the mode of sample collection affect the functional properties of umbilical veins as scaffolds for vascular tissue engineering purposes.

In Figure 4c, as Figure 4b, the localization is around the defect layer and not inside it, because this corresponds to the second mode of sample 3. Calculations for sample 3 for the peak at 1.46 GHz appears in Figure 4d, as can be seen, localization of the displacement field is not observed.

The force corresponding to 2-mm gap formation and to breaking of the suture, the mode of sample failure, the pre-repair (APR) and post-repair (AR) cross-sectional areas and the changes in tendon dimensions are listed in Table 1.

Another parameter with a significant impact on the efficiency of CE is the injection mode of sample and acid/base, e.g., HD, EKI, and their combinations.

As in recent reports on fungal specimens [ 26], the mode of sample preparation was in principle effective in releasing fungal DNA and allowing its amplification even in samples that had been stored for years.

For these reasons, the choice of sampling neoplasias that are destined for research is guided by the diagnostic needs of the tissue sample and the timing and mode of sample conservation, from excision to transport to the Pathology laboratory, storage in the laboratory and the disposal of the tissues.

A substrate-biasing-effect attenuated T switch is used during the hold mode of sample-and-hold circuit, the T type structure makes the input-dependent signal feed-through effect neglectable, and a high linearity performance can be assured.

Upon using the stochastic GA its exceedingly divers mode of sampling often resulted in poor catalytic materials in the next catalyst generation.

The simulation results show that the meso-scale structure has an important influence on the compressive strength and the ultimate failure mode of samples loaded in various directions α.

The steel fibers can change the failure mode of samples subjected to cyclic freezing and thawing.

Because of the different mode of sampling the absolute conductivity values are different; the saline solutions obtained by immersion of the poultices reach much higher values (up to 2800 µs cm−1) than those of the drill dust (up to 430 µs cm−1).