Sentence examples for mode of beams from inspiring English sources
Corrosion of stirrups and inclined bars does not change the shear compression failure mode of beams.
Column panel zone (PZ) ductility significantly affects the failure mode of beams with reduced beam section (RBS) moment connections.
Crack propagation varies with the change of fibre length and results in the variation of failure mode of beams.
The failure mode of beams with large aspect ratios tends to change from flexure to shear with increasing loading rate.
The different levels of strand corrosion in ungrouted duct have different effects on the cracking behavior, the load deflection curve, and the failure mode of beams.
The failure mode of beams RB1, RB2 and RB4 occurred by rupture of the FRP sheets at mid-span, as shown in Fig. 13 due to reaching the maximum strength of FRP (see Fig. 14).
The failure modes of beams B-0, B-2-2, B-5-2, and B-5-4 were steel plate (rebar) yield/damage and concrete crushing, whereas the failure mode of beam B-2-4 was bolt failure as seen in Fig. 12d.
At high currents, some bellows were found to be warmed by the TE mode of beam induced fields.
Figures 8 and 9 illustrate by photographs the flexural failure mode of beam B400-5-r1 and the typical diagonal tension failure mode of the beams of this investigation.
The failure mode of beam S1C was the interfacial debonding of CFRP laminates, followed by complete debonding of top and bottom CFRP laminates.
The failure mode of beam S1MN was plate-end debonding that occurred at the right end of tensile laminate, followed by complete debonding of tensile CFRP laminate.
