Sentence examples for mode exhibited a from inspiring English sources

Its mass spectra in the positive ion mode exhibited a molecular ion [M] + at m/z 449.

Therefore, the application of 2D-EF could strikingly intensify the IMAC performance and the IMAC in 2D-EF mode exhibited a good potential in protein purification from complex feedstocks.

Results from the experimental tests showed that the cutting deformation mode exhibited a high average crush force efficiency of 0.95 compared to average values of 0.66 and 0.20 for progressive folding and global bending deformation modes, respectively.

The F. graminearum cultures were grown with a native carbon source and the filtrates contained none of the compounds that were spiked for verification purposes; the only exception was 3AcDON, which in the full scan mode exhibited a maximum signal height of 1 × 10 counts for the nonspiked culture filtrates, which is too low for generating MS/MS spectra.

Calculations repeated for the substrate-bound complex (PDB id: 2FNS) confirmed that the slow-mode profile is insensitive to structural asymmetry and yielded the almost identical profiles for the two subunits, while the 2nd mode exhibited a stronger dependence on structural asymmetry (see Supplementary Material).

Mr. Gibson's film, "The Passion of the Christ," which early attendance figures suggest may become a worldwide success, reinvents the Passion in a late medieval mode, exhibiting a lusty fascination with flagellation, a fetishist's attentiveness to whips and welts, a panting anger at grotesquely caricatured villains.

The unstable mode exhibits a wave traveling with the main flow.

The soot agglomerates in the accumulation mode, exhibit a bipolar charge.

This mode exhibits a clear north south spatial gradient and very large vertical magnetic components, consistent with expectations for a spatially localized FLR signature.

This mode exhibits a compliance-free behaviour possibly due to the intrinsic series resistor by the two thin filaments formed in the ZrO2 layers.

Akisanya et al. [24] reported a higher bonded joint toughness if the failure mode exhibits a serrated crack path compared to a flat crack path at the interface of two components.