Sentence examples for mn with a from inspiring English sources
In fact, only a high PLA2R ABs titer indicates MN with a high probability, as a low titer test does not exclude MN, since 20%to30%0% of the patients with MN are negative for both anti-PLA2R and anti-THSD7A ABs, which appear to be mutually exclusive [ 10, 11], regardless of the assay used.
An exemplar prototype achieves a state-of-the-art resolution of 0.82 mN with a measurement range over 15 N.
The resulting force sensor enables the measurement of forces ranging from 1 to 600 mN with a resolution of 10 μN.
The aim of this paper is therefore to review data, testing protocols and guidance papers which describe the environmental fate and behaviour of MN with a focus on their regulatory reliability and relevance.
The maximum stroke and force are 1.56 mm and 320.5 mN with a single cell, and they are increased to be 2.8 mm and 504.1 mN with the 2 × 2 ECF artificial muscle actuator.
It is demonstrated that the output of our microforce sensor is linear, in addition to which it can measure forces higher than 3 mN with a coefficient of variation of less than 2%.
Following the 2 hour period, the basal fluid was removed and the tracer concentration was assessed using a 96 well plate fluorimeter (GMI, Ramsey, MN), with an excitation filter of 485nm and emission filter of 538 nm.
PCR was performed using a MJ Research PTC 225 Thermal Cycler (MJ Research, GMI Inc., Ramsey, MN) with an initial denaturation at 95°C for 2 minutes, followed by 45 cycles of 2 step temperature cycling of 95°C for 30 seconds, and 66 to 70°C for 30 seconds (PIK3CA, ERBB2, KRAS at 66°C; TP53, EGFR, BRAF at 68°C; GATA3, FGFR3 at 70°C).
IL-6 was measured by ultra-sensitive ELISA (Quantikine HS Human IL-6 IMinneapolis R&D SysteMN, Minneapolis, MN) with an analytical CV of 6.3% and a detection level of 0.04 pg/mL.
IL-6 was measured by ELISA (Quantiglo Human IL-6 Immunoassay; R&D Systems, Minneapolis, MN) with an assay range of 0.48 1500 pg/mL.
Serum samples (1 mL) collected at sacrifice were diluted with 4 mL 0.26% (v/v) UHP nitric acid and analysed for Si and Mn with an integration time of 1 s per increment.
