Sentence examples for mn corresponding to from inspiring English sources

Solving the resulted determinant, we get the natural frequency, ω mn, corresponding to mode (m, n).

Up to loads of 5 mN, corresponding to stresses of ≈0.5 GPa, fully reversible hysteresis loops are observed.

Figure 1 shows a typical indentation load-displacement curve of single-crystal Si(100) subjected to a maximum indentation load of 200 mN, corresponding to different phase transformations as suggested by Bradby et al. [9].

mcfp-1/HA (1:1) coacervates protected mica from damage, even at the maximum applied load, FD of 300 mN (corresponding to a pressure >2 MPa, Figure 6 ).

Bottom three traces show MN activity corresponding to KE, HF, and HE, respectively.

The lowest interfacial tension value is 1.45 × 10−4 mN m−1, corresponding to the surfactant concentration of 0.3%%.

In fact, both the yield of isoprene and the surface tension are leveling-off at surface tension lower than 39 mN m 1, corresponding to surfactant concentrations larger than ca. 1.5 mM, and clearly the isoprene yield is not proportional to the nonanoic acid bulk concentration.

FTIR spectroscopy can conclusively distinguish between layer-type birnessite and tunnel-type todorokite [15, 34], because the broad peak at ~760 cm−1 in FTIR of Mn oxides is typically assigned to an asymmetrical Mn–O stretching vibration, corresponding to corner-sharing MnO6 octahedra, which is absent in phyllomanganate Mn oxides [34].

The home agent (HA), foreign agent (FA), mobile node (MN), corresponding node (CN), care of address (CoA), visitor list (VL), and mobility binding table (MBT) network entities were introduced by MIPv4 protocol.

By applying the separability of the objective function and the technique of operator splitting, the S-subproblem can be converted into mn corresponding single variable minimization problems.

The Mn 2p XPS (Fig. 2b) shows two important peaks with a binding energy of 642.4 and 654.3 eV, corresponding to the Mn 2p3/2 and Mn 2p1/2 of Mn3(PO4)2.