Sentence examples for mm to avoid from inspiring English sources

Some have suggested using a diameter cutoff at 7 mm to avoid false-positive diagnosis [32].

The fluorescence quantum yield (Φf) was measured using diluted solutions (1.8 mM) to avoid reabsorption effect.

The slice thickness should range around 2 mm, but not exceed 3 mm to avoid partial volume effects.

The volume of water drops was set in 5 μL and the dropping height remained at 0.165 mm to avoid the effect of impaction.

In this report, the diameter of particles is 0.8 mm and the innermost orifice position is decided at 1.1 mm to avoid the crash of each particle.

A biplanar osteotomy should also be performed for corrections greater than 12.5 mm to avoid significantly decreasing the patellar height [9, 65].

These samples were collected from three representative outcrops (wpt 009, wpt 014, and wpt 015 of Meneghini et al. 2010; Rowe et al. 2011) and were carefully cut into approximately 10 mm × 10 mm × 10 mm chips to avoid the influence of surface weathering.

The sample was loaded onto a column with a flow rate of 1 mL min-1, and the column was washed at a flow rate of 2 mL min-1 with 4 CV of 50 mM Tris/HCl buffer (pH 8.0) containing 500 mM NaCl and 10 mM imidazole to avoid nonspecific binding.

The brain tissues were homogenized in an ice-cold 0.4 M perchloric acid (5 μl/mg) solution that contains 5 mM sodium bisulfate and 0.04 mM EDTA to avoid oxidation.

The beam diameter of 13 mm is sufficient to overfill the 9 mm pupil to avoid vignetting, even as the deflection of ± 3 degrees results in a beam walk of ± 1.8 mm.

Both peptides were dissolved in 10 mM NaOH to avoid aggregation and then diluted into phosphate buffered saline (PBS 140 mM NaCl, 2.7 mM KCl, 10 mM Na2HPO4 and 2 mM KH2PO4) 10 mM PBS, pH 7.4 to the required final concentration, determined by Bradford assay and by absorbance at 220 nm [ 2].